Ericsson RBS 6302 - Introduction

Introduction
1 Introduction
This instruction describes how to remove the RBS 6302 main unit and optional
Global Positioning System (GPS) receiver unit, in preparation for installing
replacement units. The main unit removal and subsequent replacement
procedures are ordinarily performed during off-peak hours to minimize traffic
disturbance.
The main unit installation alternatives are presented in Figure 1, and are the
following:
• Single unit on a pole
• Single unit on a wall
• Dual unit back-to-back on a pole
• Dual unit back-to-back on a wall
• Triple unit on a pole
1
81/1543-LZA 701 6001 Uen B | 2012-11-09