Captair Flow Smart
Mobile ductless ltering clean air enclosure
14
Settings page details
1 Device time and date settings
2
Device network settings
Mode: Selected IP protocol
Hostname: Device name on network
IP: IP address of the device
MASK: network mask
GW: Network gateway
Modify network settings :
Default mode : DHCP
Each unit is identied with its hostname : ER-UNIT-S/N
Hostname example for a Captair 321 Smart, S/N: 25698
Hosname will be: ER-321-25698
This hostname is displayed on the IP Adress label located on the back of the control panel
If the unit is not connected to a DHCP servor, the unit will automatically switch to its defaut IP address:
192.168.0.200
3
Activate/Deactivate the exchange of information
This allows the transmission of information from the device to the eGuard server for:
- remote monitoring via eGuard App (mobile &PC)
- receiving usage reports
4 Device fan setpoint settings
5
Alarm saturation lter (Molecode option)
Sensor type indication: Solvents
Sensor sensitivity settings: :
5 settings (capteur S): High sensitivity, Medium/High Sensitivity, Medium Sensitivity, Medium/Low Sensitivity,
Low Sensitivity
Sensor replacement :
Enter replacement sensor date, display the next sensor replacement date
6
Filter replacement date:
Indicates the lter type (AS: organics vapors / HP : powders)
For units equipped with carbon and HEPA lters, please use the carbon lter indication
Last replacement:
Counter showing the number of days the lter(s) can be used relative to its/their service life expiry date
7 Conrm settings key (please validate each setting )
To Next Page
Loading...