erlab Captair Flow Smart - Filter Maintenance and Replacement; Filter Configurations and Types

Captair Flow Smart
Mobile ductless ltering clean air enclosure
16
Replacing the filters
Your device is equipped with FLEX™ lter technology that was congured to the sample’s protection needs when the device
was purchased. The conguration of the lter column is dependent on the applications carried out in the enclosure. These
applications may change over time. Your FLEX™ lter technology can therefore be recongured if your workstation is used
for applications other than those anticipated when the device is rst set up. If so, please contact us so that we can verify that
the current conguration is safe or it needs to be recongured.
.
The table below summarises all possible Flex™ lter technology congurations for your device
Captair Flow 321 - 391 -Smart models
Molecular lter Particulate lter Pre-ltre
Column
Conguration
1P - x1 x1
1C1P x1 x1 -
Captair Flow 483 - 714 -Smart models
Molecular lter Particulate lter
Pre-ltre
Column
Conguration
483 714 483 714 483 714
1P - - x3 x4 x3 x4
1C1P x3 x4 x3 x4 - -
UP
The table below summarises the different types of lters that Erlab® offers along with their elds of application.
Type AS
For organic vapors
HEPA H14
For particles
ULPA U16
For particles