Captair Flow Smart
Mobile ductless ltering clean air enclosure
22
Cleaning and maintenance
Mechanical item checks
• Hinges: Hinges must be properly attached and must allow any items on the front side of the workstation to be instantly
and easily lifted upward.
• Acrylic Parts: Ensure the transparency of the panels is a part of regular maintenance for the enclosure.
Cleaning the enclosure
The enclosure must be cleaned on a regular basis. This may be accomplished in several ways:
• With soapy water followed by rinsing with clear water and drying with a soft, non-abrasive absorbent paper towel.
• Or with a commercial pH neutral product followed by drying with a soft, non-abrasive, absorbent paper towel.
• Or with a non-alcoholic disinfectant detergent.
Coated metal parts
• These must be inspected and free from any traces of corrosion.
• Check that there is no stagnant water in the spill tray.
• Clean the spill tray if necessary.
To Next Page
Loading...