1.1 Attention Before Start
● Always use Earthed/Grounded Mains socket.
● Do not connect powerful electrical machines on the same mains plug.
● Disconnect mains connector before opening the enclosure.
● Recommended load cell cable cross section is 1 mm². If the cable length is too long, use multiple
wires for ±Excitation connections.
● If the sense inputs on the load cell connector are left empty, the device will display Err 3. Make sure
all the pins are connected.
● Shielded twisted-pair cables must be used for load cell and communication.
● For best accuracy, the device shall be powered on at least 30 minutes before adjustment.
● Device setup shall be performed by authorized people.
v1.00 Page 4
To Next Page
Loading...