What to do if ESAB Welding System has poor welding performance?
If your ESAB Welding System isn't performing well, make sure the welding current supply and return cables are correctly connected. Also, verify the gas supply, ensure the correct current value is set, and check that you're using the correct welding wires. Finally, confirm that proper rolls are applied and the pressure of the wire feeder's pressure rollers is properly set.
Why is the welding current interrupted during welding with my ESAB Caddy Mig C200i Welding System?
The welding current might be interrupted because the overheating protection has tripped, which is indicated by error E4 on the display. Alternatively, check the main power supply fuses.
How to fix frequent overheating protection trips on my ESAB Caddy Mig C200i Welding System?
If the overheating protection trips frequently on your ESAB Welding System, check to see whether the air inlet or outlet is clogged. Also, make sure that you are not exceeding the rated data for the power source, meaning the unit isn't being overloaded.
How to troubleshoot no arc on ESAB Caddy Mig C200i Welding System?
To troubleshoot a no arc situation on your ESAB Welding System, check that the mains power supply switch is turned on. Also, check that the welding current supply and return cables are correctly connected and ensure that the correct current value is set.
General| Brand | ESAB |
|---|---|
| Model | Caddy Mig C200i |
| Category | Welding System |
| Language | English |
To Next Page
