ESAB PowerCut 1600 Service Manual

10
164
SECTION 9 GENERAL INFORMATION
10.0 GENERAL INFORMATION
10.1 Maintenance
VOLTAGES IN PLASMA CUTTING EQUIPMENT ARE HIGH ENOUGH TO CAUSE
SERIOUS INJURY OR POSSIBLY DEATH. BE CAREFUL AROUND EQUIPMENT
WHEN THE COVERS ARE REMOVED.
A maintenance schedule should be created and based on the following variables, amount of usage, place-
ment of machine and cleanliness of local environment. A maximum time between should be no more the
90 days.
External:Checkworkcableforworninsulationandconrmtightelectricalconnections.Checksafety
groundgroundatworkpieceandatpowersource.Checktorchcablesforworninsulationandconrmtight
electricalconnections.Drainanymoisturefromthebowloftheinputlter/regulator.
Internal:Checkfordiscoloredconnectionsastheyindicatealooseconnection.Checkallplugs,ttings
andelectricalconnectionsfortightness.Makesurecablesandhosesarenotdamaged,attenedorkinked.
With input power disconnected and wearing proper eye and face protection, blow out accumulated dirt and
foreignmaterialsfortheinsideofunit.Extraattentionshouldbegiventothennedheatsinks.
Water or oil occasionally accumulates in compressed lines. Be sure to direct the rst blast of air
away from the equipment to avoid damage to the EPP400

ESAB PowerCut 1600 Specifications

General

Brand	ESAB
Model	PowerCut 1600
Category	Welding System
Language	English