Escape P9 - USA and Canada Compliance; FCC and Industry Canada

6
User guide
USA and Canada compliance
 Do not reverse the positive and negative terminals.
 Do not connect the positive and negative terminals directly to metal objects.
 Do not connect the electrode directly to the power socket.
 Do not transport and store the battery with metal objects such as necklaces or hairpins.
 Do not throw or step on the battery.
 Do not pierce the battery with a nail or other sharp objects.
 Do not use or store the battery in high temperatures (for example, strong direct sunlight or
a vehicle in extremely hot conditions).
 If the battery terminals get dirty, clean them with a dry cloth before use.
 Only use the built-in charger of the Escape™ P9 to charge the battery.
 If the battery leaks and the electrolyte gets into your eyes, do not rub them, instead,
thoroughly rinse the eyes with clean running water for at least 15 minutes, and immediately
seek medical attention to avoid eyes injury.
 If the battery gives off an odor, generates heat, becomes discolored or deformed, or in any
way appears abnormal during use, recharging or storage, immediately remove it from the
device and dispose of it.
 If the battery's useful life expires, wrap the fully discharged battery in insulating tape and
put the battery in the specialized recycle bin.
2 USA and Canada compliance
2.1 FCC and Industry Canada
This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired
operation.
Compliance of this equipment is confirmed by the following label that is placed on the equipment:
Important: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Important: Tous les changements ou modifications pas expressément approuvés par la partie
responsable de la conformité ont pu vider l’autorité de l’utilisateur pour actionner cet équipement.