630298_3 EF5000 Installation Guide - US
2.0 Power Supply:
This appliance requires 4 ‘AA’ sized cell batteries for operation, which are located in a
battery pack at the base of the fire against the outer wall as shown in the picture below.
Alternatively, you can use the optional external power supply; described in section 2.2 of this
manual.
2.1 Replacing Batteries:
To replace the batteries, remove the fascia to gain access to the battery pack pictured
above. Pull the battery pack away from the outer wall.
Slide the battery pack lid off to access the batteries for installation/replacement of the
batteries. Ensure you replace the batteries in the correct orientation.
Once the new batteries have been placed inside, replace the lid and reattach the battery
pack to the Velcro patch on the lower right outer wall in the fireplace.
2.2 Alternate Power Source: (Optional)
If you wish to connect your outdoor fire to mains electricity instead of using 4x AA sized
batteries, you may do so using the transformer available for purchase through your Escea
retailer capable of a 6V DC output (Make sure to provide sufficient protection to the mains
connection). Connect the transformer plug into the same location on the receiver that the
battery pack plug was connected.
To Next Page
Loading...
