Quick-Start Guide
Note: You must wait at least two minutes after turning
the fireplace off before attempting to turn the fireplace
on again.
Note: Make sure to avoid pressing more than one
button by using the tips of your fingers when pressing
buttons.
Using the remote handset:
To start your fireplace:
1. Press and hold the button until you hear 2 beeps
and the handset shows a blinking series of lines.
2. Wait until the fire has lit the main burner before any
buttons are pressed.
Two basic ways to change the flame height:
Ÿ Press and hold or , to range the flame up and
down.
OR
Ÿ While the back-light is ON, you may double tap the
or button to attain a high or low flame respectively.
To turn OFF your fireplace:
Press and hold the button until the screen displays
‘OFF’.
To change the desired room temperature:
1. Press and hold the button until displays and the
numbers on the screen start to flash.
2. Press the and buttons to increase and decrease
the desired room temperature respectively.
3. To confirm press the button and wait.
NOTE: Make sure to install batteries in the remote handset and the receiver
(refer to page 5 of this manual) before operating this fireplace for the first time.
To Next Page
Loading...
