5
Advanced Operation
To Turn ON the Fireplace
Ÿ Press the button until two short beeps ON-OFF
confirm the start sequence has begun.
Pilot Flame Mode (Standby)
Ÿ Press and hold the (small flame/DOWN)
button to set appliance to Pilot Flame Mode.
To Turn OFF the Fireplace
Ÿ Press the button. ON-OFF
Flame Height Adjustment
Ÿ Press and hold (large flame/UP) button to
increase the flame height.
Ÿ Press and hold (small flame/DOWN) button to
decrease the flame height.
Installing the Batteries in the Receiver
NOTE: If batteries are installed in the receiver with
the transformer plugged in, the batteries will only be
consumed in the event of a loss of mains power.
1. Slide the cover off the receiver as shown in the
picture below.
FRONT
REAR
2.Place the 4 x AA Cell Batteries in the orientation
shown in the diagram below. We recommend using
good quality alkaline batteries.
On / Off
Flame Up
Flame Down
UP
DOWN
ON-OFF
Touch Pad
This should only be used when the remote handset is
unavailable. To access this touch pad you must
remove the fascia (refer to page 8 of this manual). It is
located in the lower right corner on the base of the
fireplace.
Automatic Turndown
The valve will turndown to pilot flame if there is not
communication with the remote and the receiver for a 3
hour period. The fire will continue to function normally
when communication is restore between the remote
and the receiver.
Automatic Shutdown
Countdown timer:
At the end of the countdown timer period, the fireplace
will turn off.
Low Battery Receiver:
If the receiver has low batteries the fireplace will
shutdown. This will not happen is the power supply is
interrupted.
FRONT FACE
Transformer Plug
Transformer plug location
The transformer plugs into the receiver as shown in the
diagram below.
To Next Page
Loading...
