21 Changi South Street 1 Singapore 486777 Phone: +65 65420833 Fax: +65 65426920
E-mail: ductless@escoglobal.com Website:
www.escoglobal.com/ductless
USER SECTION
Chapter 2 – UNPACKING YOUR CABINET
CHAPTER 2
UNPACKING YOUR CABINET
This chapter aims to provide relevant information on how to handle the cabinet properly upon receipt.
Failure to follow the following instructions may cause damage to the cabinet. We strongly advise you to
read this chapter carefully before proceeding further. Relevant information on Warranty Terms and
Conditions can be found on page 7.
2.1 STEP-BY-STEP PROCEDURE
1. Inspecting the corrugated cardboard box
Upon receipt of your new cabinet, inspect the cardboard box. If there is any visible damage to the
exterior of the box please refer to freight claim information on page 6.
2. Moving the cardboard box
a. The corrugated cardboard box has been designed to protect your cabinet from external impact.
However, excessive impact on the box may damage the cabinet too. Hence all care should be
taken to protect the box from direct impact during the course of moving it.
b. While lifting and moving the box, please ensure that the floor jack or mechanical lift truck has
entered fully under the box so that the box can be lifted stably. Otherwise there would be a risk of
the box falling off from the floor jack or mechanical lift truck during handling. Whenever needed,
please use suitably long extension bars.
c. While the box is being moved, there should be adequate gap between the ground and supports of
the pallet. The pallet should not be dragged on the ground as it would damage the pallet and
possibly the cabinet too.
3. Removing the strapping
a. Remove the strapping by cutting it
b. Do not discard the packaging material of your cabinet until you have fully installed and tested
the unit along with all its components.
4. Opening the box
a. If the unit is bundled with a support stand, you would find it strapped on top of the main cabinet
box, and onto the pallet.
b. Unwrap the protective plastic wrapping which covers the main box and the support stand box (if
present)
c. If straps are present, cut them now.
d. Open the top cover of the box by cutting the masking tape
To Next Page
Loading...
Need help?
General