Restore factory Settings
To restore MAXcam 360c to its original factory settings:
• Press and hold MRK and BRT while turning the power on.
• Restore Factory Settings? will display.
• Press the MUTE button to confirm. To cancel, wait 10 seconds.
• Factory Settings Restored will display and MAXcam 360c will reboot.
• You will be prompted to select your Time Zone and the Daylight Saving Time setting.
The following is a list of all settings available in the Programming menu followed by detailed
descriptions of each setting.
Arrow Mode
Single arrows are displayed indicating the direction of only the primary threat. All arrows use
your selected display color.
Multiple threat-direction arrows are displayed for multiple threats. When multiple threats are
displayed, the direction arrow of the primary threat will blink.
Band threat-direction arrows are color-coded for the band that is being detected. When
multiple threats are displayed, the direction arrow of the primary threat will blink.
X band = green, K band = blue, Ka band and Laser = red
Note: When using Band arrow mode with Standard FR2 and Spec FR2 meter modes, the rear bar
graph will use the selected display color.
Display Color
The display graphics can be changed to blue, green, red or orange to match the instrument lighting of
your vehicle.
Speed Display
Turns Speed Display off or on. When Speed Display is off, the vehicle’s voltage is displayed.
Cruise Alert
While traveling below the set Cruise Alert speed, all alerts sound a short double-beep. The alert will
fully sound when you exceed the Cruise Alert speed.
Programming Menu
15
To Next Page
Loading...
