Deleting User Cards/Tags by swiping
Enter programming mode.
Press 2 - a single confirmation tone will be heard
Swipe the new card/tag to be deleted, a double confirmation tone will be heard.
To delete further cards simply swipe the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already
deleted
Press the ** key to exit programming mode.
Deleting all user c
ard
s/tags
Enter programming mode.
Press 9 - a single confirmation tone will be heard.
Press 9 again - a double confirmation tone will be heard, once this tone stops the
‘delete all’ command is complete.
Press the ** key to exit programming mode.
Setting the Unlock time
Factory default door open time is set at 05 seconds.
Enter programming mode.
Press 4 - a single confirmation tone will be heard
Enter
th
e desired lock/relay operation time in a two digit format (01 to 99
seconds) - a double confirmation tone will be heard.
The Unlock time is now changed.
Press the ** key to exit programming mode.
Changing the programming code
Factory default pin 4567.
Enter programming mode.
Press 8 - a single confirmation tone will be heard.
Enter the new 4 digit programming code and press # - a single confirm
ation
tone
will be heard.
Re-enter the new 4 digit programming code and press # - a double confirmation
tone will
be heard.
Press the ** key to exit programming mode.
Reset a forgotten programming code
Turn-off power for 60seconds
Turn-on power again and press # for 3 seconds - a single confirmation tone will
be heard. Code is now reset to factory default.
13
Enterview MX Manual_Layout 2 07/10/2013 14:59 Page 13
To Next Page
Loading...
