Programming the Proximity Reader
All system programming requires the MX remote control. System programming
cannot be performed without it.
To enter programming mode press * # followed by the 4 digit programing code (The
factory default programming code: 4567) followed by #, the indication light on the
reader will change from red to amber and a long single confirmation tone will be heard.
It is mandatory
to
keep an on-site record of which user holds possession of
which numbered card/tag and what location number it is registered to.
A card/tag cannot be deleted from the system if the location number or the
whereabouts of the card/tag are unknown.
Adding User Cards/Tags using the card/tag numbers
Enter programming mode.
Press 1 - a single confirmation tone will be heard
Enter the last 6 digits of th
e n
ew card/tag to be added, a single confirmation tone
will be heard.
To add further cards simply enter the last 6 digits of the next card.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already
registered
Press the ** key to exit programming mode.
Adding User Cards/Tags by swiping
Enter programming mode.
Press 1 - a single confirmation tone will be heard
Swipe the new c
ard
/tag to be added, a double confirmation tone will be heard.
To add further cards simply swipe the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already
registered
Press the ** key to exit programming mode.
Deleting user cards/tags
Enter programming mode.
Press 2 - a single confirmation tone will be heard
Enter the last 6 digits of the new card/tag to b
e d
eleted, a single confirmation
tone will be heard.
To delete further cards simply enter the last 6 digits of the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already
deleted
Press the ** key to exit programming mode.
12
Enterview MX Manual_Layout 2 07/10/2013 14:59 Page 12
To Next Page
Loading...
