II. Appendix - Flash Download
Tool User Guide
1.
Double click the ./Tools/FLASH_DOWNLOAD_TOOLS_v2.4_150924/
ESPFlashDownloadTool_v2.3+.exe to run the Flash Download Tool.
2.
Fill the Download Path Config area with the location of the firmware which is to be
downloaded, and download it to ADDR 0x0000. SPI SPEED is 40 MHz, SPI MODE is
QIO, FLASH SIZE is 8 Mbit. And select the corresponding COM port.
#
Figure Ⅱ-1. Flash Download Tool
📖 Note:
The selected firmware in the Download Path Config area will turn into green and be downloaded into the
ESP-Launcher. If there is any other firmware which is not selected, it will be ignored.
To Next Page
Loading...
