U
SER MANUAL
> S
AFETY CONSIDERATION
Please read the instruction manual carefully before using our products to avoid accidental
mechanical hazards and improper use of the user, resulting in unclear images and
diagnostic errors. In particular, carefully read the following safety precautions to prevent
the product is damaged, personal injury, and other hazards and accidents that may
occur.
European authority representative
The slit lamp is class I medical device
Indicate outlet of the power
Indicate input of the power
2. Precautions for use
1.
The product can only be used by qualified medical staff.
2.
Do not disassemble or attempt to perform operations that are not described in this instruction manual. If
the operation is not performed properly, excessive force may cause damage to the machine or personal
injury. If the instrument fails, please read the troubleshooting guide carefully; follow the troubleshooting
methods and steps to troubleshoot the problem; if the problems remain unsolved, please contact our
Manufacturer and Service Department, and our company will arrange professional maintenance personnel
to help you troubleshoot.
3.
Do not store and use in a flammable, explosive, high temperature, high humidity and dusty environment;
use it in a clean room, keeping the product clean and dry.
4.
Other medical instruments and equipment that installed at the same site must comply with the same
electromagnetic compatibility principles. Equipment that cannot comply with or is known to have poor
electromagnetic compatibility must be installed at least 3 meters away from the equipment and must be
powered by a different power cord.
5.
Please pay attention to the rating of all electrical connection ports.
6.
Before using the instrument, please check all the wires are correctly connected; if the wires are
inappropriately connected it may cause the instrument to be short-circuited, which may cause the product
is damaged and personal injury.
7.
Users should pay attention when using the instrument, and be careful when moving the parts to avoid
damage due to the moving of the base and tilting of the projection tube
8.
When replacing fuses and other electrical components, turn off the main power switch. Replace the fuse
that meets the specifications specified in this manual.
9.
If there is a need to replace power cord, please use the power cord specified in this manual.
10.
Don't touch the surface of the lens and prism with hand or hard objects.
SL650L - Slit lamp microscope > V1 - 10-2021 - CE
To Next Page
Loading...
Need help?
General
