Essilor Instruments SL 650 User Manual

U SER MANUAL > S AFETY CONSIDERATION
3. Contraindication
4. Side effects
5. Exclusion of liability clause
6. Power Source
7. Precautions regarding IT Network
8. Electromagnetic compatibility
11. When the device is not operating, the power should be turned off, and cover the device with dust cover.
12. To prevent the instrument from falling down to floor, it should be placed on the floor where the inclination
angle is less than 10°.
13. Please deal with the waste disposal produced by the machine following relevant laws and regulations.
14. Please read the safety signs and other illustrations used on this instrument carefully to use the device
safely.
No contraindications.
No undesirable side-effects.
The results and/or technical data resulting from the handling or use of instruments must be
analyzed by professionals experienced in various fields of application of the instrument in order to
avoid any risk of misreading or incorrect analysis of the data.
Diagnostics are carried out under the responsibility of the user and Essilor declines any
responsibility for the results of these diagnostics.
Manufacturer is not responsible for damage caused by fire, earthquake, third party behavior, other
accidents, and carelessness of the user, misuse, or use under abnormal conditions.
Manufacturer is not responsible for the deficit, bankrupt, and any loss due to unable to use this device.
Manufacturer is not liable for any damage to the operation not described in the instruction.
Diagnosis is the responsibility of the doctors, and Manufacturer is not responsible for the results of those
diagnoses
100-240V.
This section is not applicable.
Below cables information are provided for EMC reference.
Cable
Max. cable length, Shielded/unshielded
Number
Cable classification
AC power cable
1.8 m
Non shielded
1 set
AC Power
DC Power cable
1.36 m
Non shielded
1 set
DC Power
DC Power cable for
the slit lamp
microscope
0.7 m
Non shielded
1 set
DC Power
USB cable for the slit
lamp microscope
0.3 m
Shielded
1 set
DC Power
USB cable for the slit
lamp microscope
1.9 m
Shielded
1 set
DC Power
Important information regarding Electronic Magnetic Compatibility (EMC)
The slit lamp microscope needs special precautions regarding EMC and put into service according to the EMC
information provided in the user manual and other documents. The slit lamp microscope complies with the IEC
60601-1-2:2014 standard.
32 SL650L - Slit lamp microscope > V1 - 10-2021 - CE

Essilor Instruments SL 650 Specifications

General

Brand	Essilor Instruments
Model	SL 650
Category	Measuring Instruments
Language	English