Programming
LSRA Configuration Program Files
The following files exist when the program is copied onto the hard
disk, or when the program is run from the floppy disk:
CMDN.BAT
A batch file used to set up the printing process and initiate the
CMDNPGM.EXE program.
CMDNPGM.EXE
The executable CMDN configuration program file.
README.TXT
An ASCII text file containing the latest program notes. This
file is readable using any text editor.
OVL Directory:
Overlay files used by the CMDNPGM.EXE program.
TEMPLATE.TXT (found in OVL directory)
A file which holds the basic formatting information for the
message report.
CONVERT.EXE
The CONVERT.EXE program allows the conversion of
existing IRC-3 data entry files (FILENAME.N) or DCPU
message files to LSRA database files. Additional information
about this utility program can be found in the Convert Utility
section of this chapter.
The following files are created when a LSRA network is
programmed:
FILENAME.PRJ
Contains data on specific project & host system.
FILENAME. Sxx
The FILENAME.Sxx contains the overall network
configuration information for each LSRA Display.
"FILENAME" is replaced with the Current Project Filename,
as entered in the configuration program.
FILENAME.Dxx
The FILENAME.Dxx files contain the display configuration
information for each LSRA display. "FILENAME" is replaced
with the Current Project Filename, as entered in the
configuration program. "xx" is automatically replaced with the
address of each individual LSRA display.
FILENAME.Mxx
The FILENAME.Dxx files contain the message information
for each LSRA display. "FILENAME" is replaced with the
Current Project Filename, as entered in the configuration
4.30
LSRA Installation, Operation, Maintenance, and Configuration Manual
To Next Page
Loading...