11
Etac / Cross 6 / www.etac.com
Click!
Click!
Rear wheels with quick-release axle
When assembling, always make sure that
the quick-release button in the hub springs
out properly. Test by pulling the wheel.
Folding
• Any drive handle and/or crossbar are
detached/unclipped.
• Fold up the foot plates.
• Lift the seat up.
Unfolding
• Push one seat post down, with your whole hand
on top of the seat.
• Do not hold the seat post when unfolding.
• Fold down the foot plates.
Anti-tip guard
• The anti-tip guards are foldable in two locking positions. The rst
locking position may be required if the anti-tip guard pushes
against the back chassis.
• When unfolding the anti-tip guard, make sure that the locking pin
snaps in properly.
• After all adjustments to the chair, the function of the anti-tip guard must be checked.
If the anti-tip guard needs to be adjusted, contact your technical aids centre.
8. Installation upon delivery
9. Handling
Leg supports with foot plates and arm supports/side covers are
delivered unassembled and must be mounted upon delivery.
Tilter is integrated in the frame
To Next Page
Loading...
