Etac Cross 6 - Rear Wheel Quick-Release Axle Adjustment; Adjusting Continuously Elevating Leg Supports

30
Etac / Cross 6 / www.etac.com
1
1
2 3
2 3
± 6 cm
Min 0.2
Max 1.2
13. Settings, readjustments
Leg supports, continuously elevating
can be adjusted.
Never stand on the foot plates, risk of tipping! When lifting
a wheelchair, remove the leg supports and lift the frame
(lower or upper frame post).
Always have screws and knobs for foot plate mounted even if
foot plate is not used.
5 mm
Amputee leg support can be adjusted.
Never sit on the amputee support. When lifting a wheelchair,
remove the amputee support, fold the other leg support under
the seat (or remove it) and lift the frame (lower or upper
frame post).
4 mm
6 mm
Rear wheels with quick-release axle
The distance between the hub sleeve and the locking balls can be
adjusted by adjusting the nut on the outside of the hub. The distance
between the hub sleeve and the locking balls should be 0.2 to 1.2
mm.
When assembling, always make sure that the quick-release
button in the hub springs out properly. Test by pulling the
wheel.