ETC ColorSource CYC - Error Codes; Interpreting Error Codes; RDM Values Reference

ETC Installation Guide
ColorSource CYC v1.6
ColorSource CYC v1.6 Page 10 of 12 ETC
Error codes
There are three error codes that may be shown on the user interface.
• : Screen toggles between and to indicate a problem
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.
•
: Screen toggles between and to indicate that the
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.
•
: Screen toggles between and to indicate that the
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
RDM values
Manufacturer ID: 0x6574 (Electronic Theatre Controls)
Model ID: 0x0215 (ETC ColorSource CYC)
Parameter RDM PID Value
DMX Start
Address
0x00F0 Range = 1–512
Personality ID 0x00E0
1 = 5 Channel
2 = Direct
3 = 1 Channel
4 = RGB
Output
Frequency
0x8123
0 = Standard (1.2 kHz)
1 = High (25 kHz)