EasyManuals Logo

ETC ColorSource CYC User Manual

ETC ColorSource CYC
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
ETC Installation Guide
ColorSource CYC v1.6
ColorSource CYC v1.6 Page 5 of 12 ETC
User interface
The user interface allows you to set the
start address of the fixture, access the
stand-alone presets and sequences, and
set the DMX control mode.
The DMX address will blink when
no DMX is present and a preset or
sequence is not active. The
inactivity time-out is disabled
while in a data loss state.
After 5 seconds of inactivity when
DMX is present, the display goes
dark.
Mode button
Pressing the Mode button activates the Preset/Sequence menu; the last active
preset or sequence plays automatically. Pressing the Mode button a second
time deactivates the selected preset or sequence. The display will revert to
show the DMX start address.
If DMX data is present, the current preset or sequence plays in the
background and DMX data continues to take priority.
If DMX data is lost and a preset is active in the background, the last
selected preset or sequence automatically plays.
Setting the DMX address
1: Press any button to wake the display. The display shows the DMX
address.
2: Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See
RDM values
on
page 10
.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ETC ColorSource CYC and is the answer not in the manual?

ETC ColorSource CYC Specifications

General IconGeneral
BrandETC
ModelColorSource CYC
CategoryDJ Equipment
LanguageEnglish

Related product manuals