Echoflex Installation Guide
LED Fixture Controller (120-277 VAC)
Supplies required to install the controller (not provided):
Appropriately sized wire nuts
Wire insulation and small cable ties
Two 3/8 inch #8 metal screws (for surface mounting strap only)
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: RISKOFELECTRICSHOCK! This device utilizes
high voltage and should only be installed by a qualified
installer or electrician. Follow all local codes for
installation. Before terminating the AC power wiring verify
that the main breaker is in the off position and follow the
proper lockout/tag out procedures required by NFPA
Standard 70E.
AVERTISSEMENT : RISQUE DE DÉCHARGE ÉLECTRIQUE!
Cette appareil utilise une haute tension et ne doit être
installé que par un installateur qualifié ou un électricien.
Suivez tous les codes locaux pour l'installation. Avant de
raccorder le câblage du courant alternatif, vérifiez que le
disjoncteur principal est en position d'arrêt et suivez les
procédures de Consignation/Déconsignation prescrites par
la norme NFPA 70E.
WARNING: For indoor use only! Must install to an
electrical junction box or wireway.
AVERTISSEMENT : Uniquement pour usage d'intérieur!
Doit être installé sur une boîte de raccordement électrique
ou un chemin de câbles.
This product is suitable for use in dry locations where the ambient
temperature is -10°C to 60°C (14°F to 140°F).
Do not use outdoors.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at heights where it is
not subject to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
Do not use this equipment for other than its intended use.
Servicing should be performed by qualified service personnel.
Pollution Degree: 2.
SAVE THESE INSTRUCTIONS
LED Fixture Controller (120-277 VAC) Page 2 of 12 Echoflex
To Next Page
Loading...
Need help?
General
