9.3 Emptying the boiler
h
All boiler parts are hot, including the water from the boiler.
1 Turn off the water tap.
2 Open the door.
3 Access the machine, see par. . Remove the side plate and the
upper plate with cover.
4 Take the drain hose D out of the holder and place it safely in a
bucket E (min. 15 l).
5 Open the hose clamp B and empty the boiler.
6 Place the hose clamp on the drain hose.
7 Put the drain hose back in the holder.
8 Fasten the plates to the machine.
9 Close the door.
9.4 Restarting
1 Check that the wiring has been connected correctly.
2 Check if the hoses and valves have been properly connected.
3 Put the plates back into their original position.
4 Connect the water supply hose again (where applicable) and
open the tap.
5 Reconnect the mains.
Switch the machine on at the on/off switch or insert the service
key.
6 Carry out the daily maintenance activities, see par. 4.5.
7 Close the door.
Wait until the software is ready.
The text indicating that machine is ready will be displayed.
Figure 9-1
D
B
E
D
B
INSTANT SMALL
INSTANT MEDIUM
To Next Page
