EasyManua.ls Logo

ETNA Dorado - General Safety Instructions and Restrictions

ETNA Dorado
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical manual Dorado Small Instant
9
© ETNA Coffee Equipment b.v.
COFFEE TECHNOLOGIES
1.9 General safety instructions and restrictions
The manufacturer does not accept liability for any damage caused by
any failure to (strictly) observe the safety instructions or by
carelessness during use and cleaning of the machine and any
associated accessories.
Depending on the specific operating conditions or accessories used,
additional safety instructions may apply. Please contact your dealer
immediately if you encounter any hazards when using the machine.
The user of the machine is fully responsible at all times for
observing locally applicable safety regulations and
guidelines.
1.9.1 Operating and cleaning instructions
All those using and/or cleaning the machine must be familiar with
and follow the operating and cleaning instructions closely. The
owner must ensure that personnel are informed of the operating
and cleaning instructions contained in this manual and that they
comply with these regulations and instructions.
Never change the order in which activities are carried out.
Always keep these instructions in the vicinity of the machine.
1.9.2 Icons and instructions
The icons, symbols and instructions attached to the machine form part
of the safety instructions. Therefore, they must not be covered or
removed. They must be kept within reach and be clearly legible
throughout the entire service life of the machine.
If icons, symbols or instructions are illegible, ring your supplier
straightaway to rectify this.
1.9.3 Users
The daily, weekly and monthly maintenance and cleaning activities
may only be carried out by users who have received training from the
installer or owner of the machine. These individuals will be familiar with
the potential risks of opening the machine.
1.9.4 Technical specifications
The technical specifications may not be modified.
1.9.5 Modifications
Modifications may not be made to the machine (or parts of the
machine).

Table of Contents

Related product manuals