25
2525462-01-01/20 (Translation of the original operating instructions)
Operating Instructions
Transponder-Coded Safety Switch CTM-LBI-BR
EN
After the cause has been remedied, faults can generally be reset by opening and closing the guard (when DIA ashes
inversely once). Otherwise, briey disconnect the power supply. Please contact the manufacturer if the fault could not be
reset after restarting.
Important!
If you do not nd the displayed device status in the system status table, this indicates an internal device
fault. In this case, you should contact the manufacturer.
To Next Page
Loading...
Need help?
General