EasyManuals Logo

EUCHNER MGB-L0xx-AR Series User Manual

EUCHNER MGB-L0xx-AR Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Operating Instructions Safety Systems
MGB-L0…-AR.-… and MGB-L0…-AP.-…
14
(translation of the original operating instructions) 112657-12-01/15
7.6. Escape release (optional)
The escape release is used to open a safety guard from the inside without tools.
Important!
Ì It must be possible to operate the escape release manually from inside the protected area without
tools.
Ì It must not be possible to reach the escape release from the outside.
Ì The actuator must not be under tensile stress during manual release.
Ì The escape release meets the requirements of Category B according to ENISO13849-1:2008.
Ì Fit escape release such that operation, inspection and service are possible.
Ì The actuation axis for the escape release must be inserted min. 10 mm into the handle module. Note the information on
the different prole widths in the next chapter.
Ì Align escape release axis at right angles to the handle module. See Figure 4 and Figure 7.
7.6.1. Preparing escape release
(also see Figure 6: Preparing escape release on page 15)
Prole width Length required for
actuation axis
Which EUCHNER parts are required? Necessary work steps
Without plates With mounting
plates
(4 mm each)
D D+13 D+21
30 mm 43 mm
51 mm Standard escape release
with 110 mm axis
(order no. 100465)
Shorten to required length
40 mm 53 mm 61 mm Standard escape release
with 110 mm axis
(order no. 100465)
If necessary
extended actuation axis (order no. 106761)
Without mounting plates:
None
With mounting plates:
Use long actuation axis and protective sleeve and
shorten to required length
45 mm
58 mm 66 mm Standard escape release
with 110 mm axis
(order no. 100465)
and
extended actuation axis (order no. 106761)
Use long actuation axis and protective sleeve and
shorten to required length
50 mm 63 mm 71 mm Standard escape release
with 110 mm axis
(order no. 100465)
and
extended actuation axis (order no. 106761)
Use long actuation axis and protective sleeve and
shorten to required length

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EUCHNER MGB-L0xx-AR Series and is the answer not in the manual?

EUCHNER MGB-L0xx-AR Series Specifications

General IconGeneral
BrandEUCHNER
ModelMGB-L0xx-AR Series
CategoryHome Safety Product
LanguageEnglish