Operation & Installation
Step 1
CAUTION
Remove the ice collecting tray and add water to the water tank.
Note: There is a maximum scale (MAX) in the reservoir. The water should not exceed the MAX
position. If the water exceeds the maximum scale (MAX), you need to open the bottom drain
plug, release the excess water, and reinstall the water tank.
When the indoor temperature is lower than 20 degrees, please choose small ice. When the
indoor temperature is higher than 25 degrees, it is recommended to choose large ice.
When these three cycles are used for the first time, the ice produced will be small and irregular.
When the ice collecting tray is full, please take out the ice immediately. The ice will melt if you
wait too long.
Step 2
Plug in the power and press the “POWER” button to start the machine.
Step 3
Select the size of the ice you want. The default mode is large ice.
07
OPERATION INSTRUCTIONS
To Next Page
Loading...
