08
Maintenance & Tips
Clean the ice collecting tray and water tank frequently. When cleaning, unplug the unit and
remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the
outside surface of the ice maker. Do not spray the ice maker with chemicals or diluted agents
such as acids, gasoline or oil. Rinse thoroughly before starting.
Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of
obstruction. Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
Restart the machine after being idle for a period of time. If the machine does not have enough
water to pump for air blockage, the water shortage indication icon is displayed. You need to
press the POWER button again to restart the ice maker.
To ensure the cleanness of ice, please change the water of the water reservoir at least once one
day. If it has not been used for a long time, please drain the water out and clean it up.
If the compressor does not work due to water shortage, if it is too full ice, or if there is a power
failure, etc., it will delay for 3 minutes to start up after being restarted.
Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
Please note, if a power failure occurs due to disconnection of the power cord, or if the power
button has been pushed off during an ice making cycle, small ice chips may form and get lodged
in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and
removing the ice chips. Restart again.
Please check if the water reservoir is level when the ice shovel cannot remove the ice from the
ice basket. If not, please push the ice shovel gently, and then press the Power button to restart.
CLEANING AND USE GUIDANCE
TIPS
To Next Page
Loading...
