CONTROL PANEL
VERSIONS: E51 V2 TRAC - E61 V2 TRAC – M510 V2 TRAC – M610 V2 TRAC
KEY-OPERATED SWITCH
The ignition sequence will start by rotating the key-operated
switch clockwise (position 1); a series of information will appear
on the display in successive order. THE BUTTONS ON THE
INSTRUMENT PANEL AND THE DRIVE CONTROLS
SHALL NEVER BE TOUCHED DURING THIS
SEQUENCE.
The charge level of the battery will appear on the display at the
end of the sequence, e.g. 100 - 90 - 80 etc.
The machine is ready to be used only at this point.
SUCTION FAN BUTTON
If the suction fan is switched off, this button can be used to turn it
on and a green light indicator will come on.
If the suction fan is switched on, this button can be used to turn it
off after a preset delay.
BRUSH RELEASE BUTTON
This button will enable the brush release sequence.
The led light will start blinking during this sequence.
This operation shall be carried out with the machine in halt
position and with the brush plate in raised position.
To Next Page
Loading...
