EUTECH INSTRUMENTS CON 700 - REV 2 - P3.2 ºC ºF (Celcius or Fahrenheit); P3.3 Atc (Automatic Temperature Compensation); P3.4 Tds (Total Dissolved Solids Factor); P3.5 T.co (Temperature Coefficient)

Press to confirm.
6.5 P3.2 ºC ºF (Celcius
Or Fahrenheit)
Press
.
Press
or to select ºC or ºF.
Press
to confirm.
6.6 P3.3 AtC (Automatic Temperature Compensation)
Press
.
Press
or to select “Yes” or “No”.
Press
to confirm.
6.7 P3.4 tdS (Total Dissolved Solids factor)
Press
.
Press
or to select the desired TDS factor (.40 to
1.00).
Press
to confirm.
6.8 P3.5 t.CO (Temperature Coefficient)
The temperature coefficient is the amount of change in conductivity per
degr
ee temperature (% per ºC). The CON 700 is factory set to a
temperature coefficient of 2.1 % per ºC. For most applications this will
provide good results. The meter allows adjustment from 0.0 to 10.0.
TIP: Select 0.0% for uncompensated measurements. The temperature
w
ill be measured by the electrode and displayed in measurement
mode—without compensation.
See Section 8
– Calculating Temperature Coefficients.
10