2. GETTING STARTED
2.1 Keypad Functions
Powers the meter on and off. Upon power on, the meter
automatic
ally begins in the mode that was last used.
Calibration and memory values are retained even if meter
is unplugged.
Toggle between available measurement modes—
Con
ductivity with Temperature or TDS with Temperature.
Also used to switch to Temperature calibration during
Conductivity or TDS calibration mode.
Press and hold for 5 seconds to enter SETUP mode.
Toggles between measurement and calibration modes.
In SET
UP mode, returns user to the measurement mode.
Confirms calibration values in CAL mode.
Confirms selections in SETUP mode.
Changes range and resolution in MEAS mode.
View recalled values in memory mode.
MI (Memor
y Insert) stores values into memory.
S
Increase value. Scroll up in SETUP & CAL modes.
MR (Memory Recall) recalls values from memory
T Decrease valu
e. Scroll down in SETUP & CAL modes.
Freezes measured reading. Press again to resume
live reading.
2
To Next Page
Loading...
