EUTECH INSTRUMENTS CON 700 - REV 2 - Default Chapter; Table of Contents

TABLE OF CONTENTS
1. INTRODUCTION .............................................................. 1
2. GETTING STARTED........................................................ 2
2.1 Keypad Functions ...................................................................2
2.2 LCD Annunciators...................................................................3
2.3 Meter Connections..................................................................3
3. ELECTRODE INFORMATION......................................... 4
4. CALIBRATION................................................................. 4
4.1 Automatic or Manual Calibration .............................................4
4.2 Single or Multi-Point Calibration..............................................5
4.3 General Calibration Tips .........................................................6
4.4 Automatic Conductivity Calibration Procedure ........................6
4.5 Manual Conductivity & TDS Calibration Procedure.................7
4.6 Temperature Calibration .........................................................7
5. MEASUREMENT.............................................................. 7
5.1 Taking Measurements.............................................................7
5.2 Automatic and Manual Ranging ..............................................8
5.3 HOLD Function .......................................................................8
5.4 Storing and Recalling Data .....................................................8
6. SETUP FUNCTIONS........................................................ 9
6.1 P1.0 CAL (Calibration) ............................................................9
6.2 P2.0 ELE (Electrode Information)............................................9
6.3 P3.0 ConF (Configuration) ......................................................9
6.4 P3.1 rdY (Ready / Stability Indicator) ......................................9
6.5 P3.2 ºC ºF (Celcius Or Fahrenheit) .........................................10
6.6 P3.3 AtC (Automatic Temperature Compensation).................10
6.7 P3.4 tdS (Total Dissolved Solids factor)..................................10
6.8 P3.5 t.CO (Temperature Coefficient).......................................10
6.9 P3.6 t.nr (Normalization Temperature in ºC) ...........................11
6.10 ACAL (Automatic Conductivity Calibration).............................11
6.11 SPC (Single Point Calibration) ................................................11