1. Disconnect the device from a power source.
2. Remove the reservoir by sliding it up.
3. Pull out the safety panel to reach the cartridge.
4. Take out the old cartridge by moving it forward.
5. Place a new cartridge in place of the old one; this should fit easily
as the new cartridge will have not yet expanded from previous uses.
Check the orientation and keep pushing until the cartridge is in the
centre of the device.
6. Put the safety panel back to hide the cartridge.
7. Put the reservoir back in place.
8. The device is ready to use.
Important:
— Depending on usage and storage, the cartridge can last 3-6 months.
— Poor water quality reduces the longevity of the cartridge.
— The new cartridge can be stored for up to 3 years without losing its
evaporation potential.
— Whilst replacing the cartridge, do not remove any parts other than
those described in this guide.
— The built-in microchip monitors the lifespan of your cartridge. When
the cartridge expands, the evaSMART air cooler turns red to remind
you to change the cartridge.
REPLACING THE
CARTRIDGE
1
2
3
4
TAKE NEW
CARTRIDGE
5
6
7
8
23
To Next Page
Loading...
