3. Put the reservoir back in place.
4. It is highly recommended to connect the device to power source again
and set the device to run on the maximum fan speed for at least one
hour afterwards to dry the water out from the internal reservoir.
5. Disconnect the device from the power source. The device is ready
for transportation.
Important: Even if there is no water in the internal reservoir, the evaporative
cartridge could still be wet. Do not transport the device on long distances with
a wet cartridge; please see section “Storage during long periods of no usage”.
For shorter distances, make sure that the device with a wet cartridge is not
isolated in a box or bag with no air flow.
Temperature parameters
evaSMART Air Coolers work by using natural evaporative cooling so its
power level can change in various climates. The charts below summarise
the cooling power approximates in different aerial conditions in both
Centigrade and Fahrenheit.
3 4
5
MAX
60 min
13
To Next Page
Loading...
