1. Disconnect the device from
the power source.
2. Remove the reservoir by sliding it up
and drain the water from it.
The air cooler creates a personal comfort zone. To be in the centre of that
zone, place the device within one metre (3 ft) of your position with its front
grill facing you. To keep the device from causing any obstructions, place it
slightly to one side of your position. In this way, you will always have room
for your laptop, book or anything else needed for your activities.
Filling the reservoir
The device only needs water to work properly. You should remove the reservoir
from the left side of the device, fill it with water and then place it back.
The water will start flowing automatically.
Depending on the quality of the air in the room, the full reservoir should provide
from 6 to 8 hours of uninterrupted cooling. To extend this time you need
to fill up the reservoir, place it in the device, wait until the cartridge is full
of water and then refill the reservoir. After this operation, the running time
will be extended by 1 to 3 hours. For instance, this may be useful if you want
to use the device whilst you sleep. The transparent reservoir lets you assess
the water level instantly. It is worth mentioning that the evaporative cartridge
will absorb up to 400 ml of water which means that once the reservoir is empty,
the device will continue cooling for another few hours. The default mode
will have the device notify you by illuminating the reservoir in red when the water
runs out. You can turn off these notifications at any time via the mobile
application. When the water runs out completely, the device will continue
working as a regular fan. You can use the replaceable reservoir whilst the
device is working as it will not affect its operation.
Moving and transportation
Before any kind of transportation, the device should be disconnected
from the power source. In addition to the water in the transparent reservoir,
the device also stores some water in the internal tank so that the evaporative
cartridge can absorb it. Before transportation, it is highly recommended to
empty the reservoir and set the device to run on the maximum fan speed
for at least one hour to dry the water out from the internal reservoir.
Transportation without drying the water out the internal reservoir is to be
attempted at your own risk. Water leakage during the transportation is not
covered by the warranty. In order to avoid leakage, the device should be
positioned horizontally and moved slowly.
In order to remove the water instantly from the internal reservoir and prepare
device for transportation, please complete the following:
1
2
11
To Next Page
Loading...
