1. Slide the water reservoir up.
2. Open the lid to fill up the reservoir. Fill with water.
3. Place the reservoir back onto the base. Make sure it is installed properly.
4. Use the cable to connect the device to the power source.
Press the Power button.
5. The device will switch on. The Power button on the top of the device
will light up and a short vibration will follow.
— Do not block the front and back grills of the device.
— Do not turn the device upside down; this will disrupt its functionality.
— Do not submerge the device in water or any other liquids; see cleaning
guide below.
— Do not place open fire sources (candles, etc.) on top of the device.
— People with limited physical, visual or mental abilities or lacking proper
experience and/or knowledge should never use the device without the
supervision of those responsible for their safety or those capable
of assistance in using the device.
— The device can be switched off completely only when it is disconnected
from the power supply.
— The manufacturer does not bear any responsibility for any damage arising
from failure to comply with this product guide.
— A replaceable evaporative cartridge is designed specifically for this product.
To maximise the effect of the device the cartridge should be changed
every 3-6 months depending on air and water conditions. If your cartridge
has been broken or damaged, you can purchase a replacement at
Evapolar.com or with your local retailer.
FIRST START
1 2
4 5
3
6 7
To Next Page
Loading...
