19
Using with the 5-pt Harness
IMPORTANT: If you are using the lower anchor
connector assembly to secure the child restraint, DO NOT
use the vehicle seat belt.
1. Disconnect tether
hook and lower
anchor connectors
from the back of
the child restraint.
Installation with Lower Anchor
Connector Assembly
Tether
Strap
2. Place the child restraint in position.
Set child restraint on vehicle seat in forward-facing
position.
Lay the tether strap over the back of the vehicle seat.
The lower anchor connector assembly that comes
with your child restraint is shown below.
A
Press the adjuster release button
A
to loosen.
• To avoid a strangulation hazard, you MUST store the
unused lower anchor connector assembly, with all slack
removed, in storage area on the back of the seat. Roll
or fold excess lower anchor connector strap and secure
with a rubber band to prevent serious injury to vehicle
occupants.
WARNING
DEATH or SERIOUS
INJURY can occur.
To Next Page
Loading...
