33
1. Convert child restraint to booster seat.
See “Converting into a Booster Seat,” p. 34.
2. Secure booster seat to the vehicle seat.
Make sure the bottom and back of the booster
seat are touching vehicle seat and back.
Level the booster seat (Canadian models only), p.
39
.
IMPORTANT: You may use the tether strap and lower
anchor connectors to secure this booster seat to the
vehicle seat as long as the position of the booster seat
in the vehicle and/or the resulting fit of the vehicle seat
belt over the child are not affected.
3. Place the child in the booster seat.
Make sure the child’s back and bottom are flat against
the back and bottom surfaces of the booster seat.
Make sure the booster seat is level.
4. Secure child and booster seat to
vehicle seat.
Stretch the lap/shoulder belt across the child and
fasten the buckle.
The shoulder belt MUST be routed properly (p. 38).
Make sure the shoulder and lap belts are threaded
under the lap belt guide.
5. Check your work.
Make sure the lap belt is stretched low and snug
across the child’s hips, within the belt guides, and
fastened into the buckle. The shoulder belt must
cross the child midway between his/her shoulder
and neck.
Booster Installation Checklist
• The shoulder belt MUST NOT cross the child’s neck
or fall off the child’s shoulder. If you cannot adjust
the shoulder belt to properly lay midway between
the child’s shoulder and neck AND at or above the
shoulder, try another seating location, or do not use
the booster seat.
WARNING
DEATH or SERIOUS
INJURY can occur.
Using as a Booster Seat
To Next Page
Loading...
