20
Installation with Lower Anchor
Connector Assembly
4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle
seat while pulling up
on the lower anchor
connector assembly
strap to tighten.
Belt Path
IMPORTANT: To properly protect the child, the child
restraint MUST NOT move more than 2.5 cm (1 in) from
side-to-side or from front-to-back at the belt path. If
you cannot tightly secure the child restraint, try again or
move it to another location.
Lower
Anchor Bar
Lower
Anchor Bar
Near Side
Far side
3. Attach lower anchor connectors.
Attach a lower anchor connector onto each lower
anchor bar.
IMPORTANT: Make sure both lower anchor connectors
are facing upward and the lower anchor connector straps
are not twisted.
Center installation in a non-standard LATCH position:
Center installation of this child restraint is permitted
using inner Lower Anchor Bars from the outside
seating positions if:
1. your vehicle manual allows such installation; and
2. the inner Lower Anchor Bars from the outside
seating positions are 28-51 cm (11-20 in.) apart.
To Next Page
Loading...
