Evenflo Chase Plus - Installation with Seat Belt

22
Installation with Seat Belt
IMPORTANT: If you are using the vehicle seat belt to
secure the child restraint, DO NOT use the lower anchor
connector assembly.
1. Disconnect tether
hook from the
back of the child
restraint.
Tether Strap
2. Place the child
restraint in
position.
Set child restraint on
vehicle seat in forward-
facing position.
Lay the tether strap
over the back of the
vehicle seat.
3. Route vehicle
seat belt through
belt path and
buckle it, as
shown.
Vehicle
Belt Path
NOTE: Lift the restraint’s seat pad away for easier access.