39
Canadian Models Only
Leveling the Booster Seat
Screw
Installing the Cup Holders
General Information
If the level line is not
parallel to the ground,
before fastening the
booster seat to the
vehicle seat, place a
tightly rolled towel/
small blanket beneath
the bottom rear of
the booster seat, as
shown.
Towel/Small Blanket
Level Line
Not available on all models.
Place each cup holder onto the seat, then turn the
seat over and secure each cup holder with a screw, as
shown. Do not over tighten. Make sure each cup
holder is attached securely in place.
NOTE: Cup holders are
not required for proper
operation of this child
restraint.
To Next Page
Loading...
