23
Using with the 5-pt Harness
4. Remove all slack from the seat belt.
Push downward on child restraint while tightening
seat belt to remove excess slack.
Lock the seat belt. In
most vehicles, you can
switch your shoulder belt
retractor into locking
mode by pulling shoulder
belt all the way out and
letting it rewind into the
retractor. Pull on shoulder
belt to make sure it is
locked.
NEVER install this Car
Seat using a non-locking
vehicle lap/shoulder belt.
Installation with Seat Belt
5. Install Locking Clip (not included), if
necessary.
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
If your vehicle was built prior to model year 1996,
and has a lap/shoulder belt that is equipped with
an emergency locking retractor (ELR) AND sliding
latch plate, you MUST use a Locking Clip. Check your
vehicle owner’s manual to identify which vehicle belt
system is in your vehicle.
If your vehicle requires a
Locking Clip, please call
ParentLink at 1-800-233-
5921 (U.S.) or 1-937-773-3971
(Canada) to obtain a Locking
Clip and instructions.
• Consult your vehicle owner’s manual before
installing a locking clip.
• DO NOT use a Locking Clip in
booster mode.
• Remove Locking Clip from
vehicle seat belt when not used
with a child restraint, or the
vehicle seat belt will not properly
restrain an adult or child.
WARNING
DEATH or SERIOUS
INJURY can occur.
Locking Clip
installed
properly.
13 mm
(0.5 in.)
To Next Page
Loading...
