Eventide TimeFactor - MIDI Transmit Enable and SysEx Options

TimeFactor User Guide System Menu Tree
49
Note: When a Factor Preset is recalled with a MIDI program change message, MIDI Program
Change messages are not generated.
Note: MIDI Program Change Transmit must be enabled in order for TimeFactor to transmit
Program Change messages. MIDI Program Change Transmit is turned ON or OFF in the MIDI
menu. Default is OFF.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[CTL XMT] – MIDI Continuous Controller Transmit Enable (ON, OFF)
Press the Encoder to select. Turn Encoder to set MIDI Continuous Controller transmit ON or
OFF.
This setting determines if Parameter Knobs transmit MIDI control messages.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[PGM XMT] – MIDI Program Change Transmit Enable (ON, OFF)
Press the Encoder to select. Turn Encoder to set MIDI Program Change transmit ON or OFF.
If ON, a MIDI Program change message is transmitted whenever a Footswitch is pressed for
Preset load.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[SYS ID] – MIDI SysEx ID (1-16)
Press the Encoder to select. Turn Encoder to choose the MIDI SysEx ID for Backup and Restore
of Presets and System settings. This should normally be left at 1.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[OUTPUT] – MIDI Transmit/Thru Select (XMT, THRU)
Press the Encoder to select. Turn Encoder to select MIDI output to either transmit (XMT)
TimeFactor MIDI data or pass incoming MIDI data THRU TimeFactor. If THRU is selected, the
TimeFactor cannot generate any MIDI messages.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[DUMP] – Dump Select (ALL, CURRENT, PRESETS, SYSTEM)
Press the Encoder to select. Turn Encoder to set what is being backed up via SysEx Dump or
Dump Request.
If ALL is selected, all saved Presets and System settings are dumped.
If CURRENT is selected, only the currently loaded effect is dumped.
If PRESETS is selected, all 100 Presets are dumped.