TimeFactor User Guide System Menu Tree
48
[RCV MAP] – Create a MIDI Program Change Receive Map
MIDI maps are an efficient way to instantly recall any of TimeFactor’s Presets using your
favorite MIDI controller (pedal board, sequencer, etc.).
Press the Encoder to select and create a MIDI Program Change Receive Map. This function
sets the corresponding Preset that is recalled when a MIDI Program Change message is
received. (Referred to as Prg No. from here on.)
The left field displays the Prg No. (0-127) and right field displays either OFF, the Preset as
Bank:Preset (1:1-50:2), TOG, BYP, or ACT.
TOG toggles the unit between bypass and active, BYP bypasses the unit, and ACT makes the
unit active.
There are two ways to select the MIDI Prg No: manually or using Learn Mode. To select
manually, with the left arrow flashing, simply turn the Encoder to select the desired Prg No.
from 0 to 127.
To use Learn Mode, press the Left Footswitch again. In LEARN mode, the Prg. No. will be
automatically set when a MIDI Program Change message is received. Pressing the Left
Footswitch exits LEARN mode.
Press the Right Footswitch to select the Bank Preset field (indicated by a flashing right hand
arrow) and turn the Encoder to select the Preset.
To map another Prg No. to another Preset, simply press the Left Footswitch again to select
the desired Prg No. and then the Right Footswitch to map it to the desired Preset.
Default map: Prg No. 0-99 map to the 100 Presets starting with Bank 1:1.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[XMT MAP] – Create a MIDI Program Change Transmit Map
In Bank Mode, when a Footswitch is used to recall a Preset, a MIDI Program Change message
can be transmitted from the MIDI Out jack or USB to control an external device (e.g. another
Factor series Stompbox, an Eventide Eclipse, an Eventide H000FW, etc.).
To Create a MIDI Program Change transmit map Press the Encoder to access the MIDI
transmit map for editing.
The left field displays the Bank Preset number (from 1:1 to 10:2). The right field displays
either OFF or the Prg No. (0-127).
Press the Left Footswitch to select Preset/Effect field (indicated by a flashing left hand arrow
pointing), turn the Encoder to select the Preset.
Press the Right Footswitch to select Prg No. field (indicated by a flashing right hand arrow
pointing to MIDI Program Change #), turn the Encoder to select the corresponding number.
Default map: Prg No. 0-99 map to the 100 Presets starting with Bank 1:1.
To Next Page
Loading...
