7 For Professional Technical Support call 1-844-241-5521
Operation
NOTE: Make certain you unwind the garden hose completely. Kinks in the hose will restrict the pump, preventing it from priming, which is the
first step to pumping water. This pump has water detector sensors. As long as the water level is over 1-1/4 in., the pump will automatically
start operating.
1
Plugging in the pump
2
Operating the pump
WARNING: Do not allow the plug to fall in water and do not
stand in water while the pump is plugged in.
NOTE: The pump will not start working unless the water
level is over 1-1/4 in.
If the water level is over starting level 1 1/4 in, the pump will
automatically start and pump out water until the water level is
down to 1/4 in. When water reaches starting level 1 1/4 in
again, the pump will start again.
WARNING: Not for permanently installation as a sump
pump.
WARNING: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or in
water while the pump is plugged in.
NOTE: Place upright on a solid base.
Place the pump on a solid base in a flooded area or any place
that you would like to remove water. Plug the pump into a 115
volt GFCI power outlet.
To Next Page
Loading...
Need help?
General
