10
WARNING!
It is dangerous to open the door when washing, because the hot water & steam may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal for the dishwasher to be wet inside.
Empty the lower rack first and then the upper one. This will avoid water dripping from the upper rack onto
the dishes in the lower one.
Forgot to Add a Dish?
At the End of the Wash Cycle
Changing the Program
If you open the door , the machine will pause. The program light will
stop blinking and the buzzer will sound every minute unless you close the door. Once
you close the door, press the start/restart button & the machine will restart working after
10 seconds.
during a wash cycle
NOTE:
Premise:
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent”).
Press the start/reset button for more than 3 seconds & the machine will go into the standby state. You can then
change the program to the desired cycle setting (see the section entitled " Starting a wash cycle. . ." ).
The program lights show the state of the dishwasher:
a) All program lights off--------------------------------------------------stand by
b) One of the program lights on-----------------------------------------pause
c) One of the program lights blinking-----------------------------------run
c) Some of the up three program lights blinking fast----------------error
1
2
3
NOTE:
When you press the Start/Reset button to pause during washing, the program light will
stop blinking and the dishwasher will sound every minute unless you press the
Start/Reset button to start again.
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working, you can open the door
completely.
2
3
Wait 10 seconds for the spray arm to stop spraying &
then open the door a little.
1
4
5
6
Press the start/reset button
Press the start/reset button, the dishwasher will run
after 10 seconds.
To Next Page
Loading...
