The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance cleaner.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to catch the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
Please take frost protection measures on the dishwasher in winter where temperatures drop below freezing.
Every time after use, please ask a service technician to:
Caring for the Dishwasher
- Inspect the filters for blockages every time after the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Remarks:
Cleaning the Filter
Cleaning The Door
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures
on the last page and reinsert the entire assembly in the dishwasher, positioning it in its seat and pressing downwards.
The entire filter assembly should be cleaned once a week.
NOTE:
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
n
n
n
Cleaning the Spray Arms
12
NOTE:
If your dishwasher cannot work because of ice, please contact professional a service technician.
To remove the spray arms, screw the nut off clockwise to
take out the washer on top of the spray arm and remove the
arm.
Wash the arms in warm soapy water and use a soft brush
to clean the jets.
Replace the parts after rinsing them thoroughly.
2
1
1
2
To Next Page
Loading...
