Combustion air is admitted at the underside at the front and rear of the combustion chamber.
GAS CONNECTIONS
FOR PROPANE CYLINDER CONNECTION
1. To achieve the optimum performance from your Everdure Barbecue, an approved gas cylinder (POL
fitting) of 9kg capacity must be used.
2. Connect the cylinder to the barbecue, via the hose and regulator. Firmly tighten joints, but do not over-
tighten. Take care not to damage the regulator fitting. Check that ALL Barbecue and Wok Burner valves
are in the Off position before opening the gas cylinder.
NOTE: Only one gas cylinder should be stored inside the trolley at any one time.
LEAK TESTING
1. Make sure gas control knobs are Off and turn the cylinder valve On.
2. Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is
present, bubbles will appear (or you may hear a hissing sound). Retightening connections can generally
repair a leaking joint. You must also check the gas hose and connection at the gas cylinder. If a leak
cannot be resolved, do not proceed.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.
LOCAL AUTHORITY REQUIREMENTS
Check Gas Type and specifications plate on the left-hand side of the barbecue. All gas fitting work, service
and repairs can only be performed by an authorized person in accordance with AS 5601 & your local gas
regulations.
NATURAL GAS
All barbecues are supplied for use with propane gas. For natural gas usage, a conversion kit must be
purchased and installed by a gas fitter or Everdure Service Technician. Please see the separate NG
conversion and installation instruction at the end of this instruction manual for details.
Barbecue only
LENGTH (mm)
To Next Page
Loading...
